#Logitech trackball mouse driver tbc21 how to#
#Logitech trackball mouse driver tbc21 .exe#
#Logitech trackball mouse driver tbc21 install#

An extra precaution is to create a new directory /opt/etc and put the file there, then symlink it to the original. A solution is to create a new nf with only the contents of this section. Tip: Upgrading from 18.10 to 19.04 the modified nf was overwritten back to the distribution version. The remainder of this section refers to this as the X Configuration File.

If editing nf does not work, edit /etc/X11/nf instead. (Note: Do not create your own directory as it can disable your keyboard and freeze X.)Īdd a new InputClass section of nf using one of the example configurations below. In Ubuntu 18.04, it is located in /usr/share/X11/Įdit nf in that directory.Locate the existing directory: locate | grep d$ To get your Marble Mouse working in Ubuntu 18.04, complete the following steps: This requires some minor tweaks to the options. In 18.04, things are mostly the same as prior, but the driver has shifted from 'evdev' to 'libinput'.

#Logitech trackball mouse driver tbc21 how to#

This section guides the reader on how to establish a working trackball, tested using Ubuntu 18.04 through 19.04 (note the middle click caveat above). This article is about how to make that happen. However, the mouse lacks scroll buttons and middle button. Without any special configuration, the mouse would work the way expected: This knowledge will help you create your own mappings, if desired. What Logitech calls left and right button are coded 1 and 3, with no middle button the small buttons Logitech calls 'Forward' and 'Backward' are coded as back (8) and forward (9). This document describes how to configure the Logitech TrackMan Marble Mouse (USB), shown in the following figure: Setting options via HAL may not work in Ubuntu 9.10 by default.Horizontal and Vertical Scrolling Example.Example Configuration #3, forgo 'Back' button.Example Configuration #2: add middle mouse button emulation.Example Configuration #1: add wheel emulation feature.If you miss that window go to the Control Panel click on Mouse and it will bring up the Trackball Explorer in the Mouse Properties window. You will probably get a message saying 'this software may not work on this version operating system' or something like that, say Yes/OK to continue.Īfter the installer runs it will show a little your device is ready window in the bottom right of the screen click that and set up your mouse buttons. Steps d-f can be done for all users (which I would do even if I planned to be the only user) by clicking the 'Change settings for all users' button at the bottom of the window and checking those two boxes there.

#Logitech trackball mouse driver tbc21 .exe#

exe file and click run as administrator (running installer as administrator may not be necessary, but I did this and it worked so.) OK your way out of those windows and then right click the. Put a check mark on Run this program as an administrator under Privilege Level. Put a check mark on Run this program in compatibility mode for.Į.

#Logitech trackball mouse driver tbc21 install#

To install the drivers in compatibility mode follow these steps:ĭ.